Pilot in Loop Assessment of Fault Tolerant Flight Control Schemes in a Motion Flight Simulator

Pilot in Loop Assessment of Fault Tolerant Flight Control Schemes in a Motion Flight Simulator

4.11 - 1251 ratings - Source

This research presents the pilot in the loop tests carried out in a Six-Degree of Freedom (6-DOF) motion flight simulator to evaluate failure detection, isolation and identification (FDII) schemes for an advanced F-15 aircraft. The objective behind this study is to leverage the capability of the flight simulator at West Virginia University (WVU) to carry out a performance assessment of neurally augmented control algorithms developed on a Matlab/Simulink RTM platform. The experimental setup features an interface setup of Gen-2 SimulinkRTM schemes with MOTUS Flight Simulator (MFS). The set up is a close substitute to a real flight and thus is helpful in evaluation of the schemes in a realistic manner. The graphics in X-plane is used to obtain visual cues and the motion platform is used to obtain motion cues in the simulator cockpit. The whole set-up enables the pilot to respond with a joystick in the advent of a failure as he would otherwise in a real flight. The pilot response in maintaining the mission profile is different for different neural network augmentations and thus an indication of performance comparison of these schemes. Secondly, FDII schemes are developed for a sensor and actuator failure using an adaptive threshold for cross-correlation coefficients of the angular rates of the aircraft. Failure detection, isolation and identification logic is formulated based on monitoring the cross-correlation parameters with their Floating Limiter (FL) bounds. The FDII scheme developed shows a good performance with desktop simulation because of no pilot activity but with a pilot in the loop significant cross-correlation of the rates occur and hence the scheme become more susceptible to wrongs FDII. In addition, the pilot might induce some coupling of the cross-correlation parameters between detection and identification time which may trigger false detections and may configure the controller differently based on incorrect detection. Thus it is necessary that FDII scheme accommodate real flight conditions. The performance of the FDII schemes is improved with a pilot in the loop by monitoring the cross-correlation parameters and fine tuning FDII algorithms for real situations. This study has set up an excellent example to effectively utilize the aural, visual and motion cues to create a higher level of simulation complexity in designing control algorithms.1-2-A locked slat on a Boeing 737 -844 (courtesy www.airliners.net) 3 Figure 1-3 A comparison of visual cue improvement (1982 to 2004) 4 Figure 1-4- LAMARS ... 3-1 -General Block Diagram for IPCS Gen-2 Controller Scheme [46] 17 Fig.

Title:Pilot in Loop Assessment of Fault Tolerant Flight Control Schemes in a Motion Flight Simulator
Author:Girish Kumar Sagoo
Publisher:ProQuest - 2008


You Must CONTINUE and create a free account to access unlimited downloads & streaming