Thus, for the 30Ad exhaust valve face angle and a 1Ad interference angle, the insert seat grinder wheel must be dressed to grind ... After the seat has been ground, use a dial gauge to check concentricity of the seat relative to the valve guide. ... (4 ) The width of the valve seat on both the exhaust and service intake inserts is 3/ 32 inch. ... (1) The outer diameter of all camshaft bearing journals is 2. ... If the installation of new standard bearings does not reduce the end clearance to less than 0.
|Title||:||Intermediate (field) (direct and General Support) and Depot Maintenance Manual|